The WIRE VISE and FAST SPLICE can fasten H-T wires without a tool.
Merely insert the wires into the holes. The wires are gripped by
spring-loaded clamps which tighten more securely as the wires are
pulled harder, holding the wires at over 80% of the breaking
strength of the wire itself.
The FASTSPLICE is double sided for joining two ends of wire on
in-line splices whereas the FASTVISE is half of a FASTSPLICE and is
used for terminations at an end post. Each wire on a fence requires
To use the FASTVISE, drill a 3/8 inch hole through the end post and
pull the wire through the hole. Then put the FASTVISE on the wire
and tap it lightly into the hole. If final tensioning is to be done
with the FASTVISE, it is recommended to pull the wire to the end
post with a chain grab, then push the slack through the hole and
FASTVISE. A special tightening tool (TVT) is also available for use
with the FASTVISE. It grabs the wire which has been threaded into
the FASTVISE and a simple prying action pulls the wire through the
FASTVISE to the desired tension.
A TWR wire release tool can be used to remove most 12.5 gauge
FASTSPLICE from the fence wire. This allows the FASTSPLICE to be
reused if care is taken during both initial installation and later
QUICKVISE /QUICKLINK Packing specification
|Serial number||name||Packing quantity (pcs/carton)||Packing specification (MM)||Product unit weight (KG/PCS)||Gross weight per carton (KG/carton)||Description|